These are all quite important. The so called "fuses" are a pair of 8 bit non-volatile configuration registers. They can be programmed by avrdude using their own particular protocol. It is quite possible to "brick" your attiny13a by setting unfortunate fuse values. This apparently can be recovered using something called "high voltage" programming (the high voltage is simply 12 volts applied in a certain way). However this is inconvenient as most folks don't have a high voltage programmer handy.
There are also a pair of "lock bit" that are much like fuse bits, but if cleared make it impossible to read (or even modify) fuse bits, eeprom, and flash. These can be restored to "1" values by a device clear command.
There are two sets of fuses, called "high" and "low".
The Lpodkalicki blink example sets these to 0xff (none of these special features are enabled).
0x80 - unused 0x40 - unused 0x20 - unused 0x10 - self programming enabled 0x08 - debugwire enabled 0x04 - brownout threshold 0x02 - brownout threshold 0x01 - external reset disabled
The Lpodkalicki blink example sets these to 0x6A = 0110 1010. These are the default settings.
0x80 - 0 - serial programming enabled. 0x40 - 1 - preserve EEPROM through chip erase 0x20 - 1 - WD timer always enabled 0x10 - 0 - divide clock by 8 0x08 - 1 - select startup time 0x04 - 0 - select startup time 0x02 - 1 - select clock source 0x01 - 0 - select clock sourceThe value of "10" for select startup time gives maximum startup time.
The Biscotti flashlight software sets 0x7A for the low fuse value. This does not divide the oscillator by 8, so we get a full speed 9.6 Mhz clock. This is also the case for the Toykeeper "STAR" hello world application.
There are 4 possible clock sources, as follows:
00 - external clock 01 - 9.6 Mhz internal RC 10 - 4.8 Mhz internal RC 11 - internal 128 kHz oscillator (low power)Section 6 of the datasheet has lots of information about the clock
Tom's Electronics pages / [email protected]